DIY: Government Issued Fake ID

This is a kit i've put together to create fake ID's. The scan is from Manitoba, Canada. Print front and back and place index card in between sides. Trim on all sides and laminate in plastic laminate that can be found at an office store.

udp://tracker.openbittorrent.com:80
udp://open.demonii.com:1337
udp://tracker.coppersurfer.tk:6969
udp://exodus.desync.com:6969

mista_g_ (2009-03-13)

Feedback is welcomed. I made about 20 of these while I was making them, all of them successful. Again, have fun, and be responsible.

mista_g_ (2009-03-13)

Instructions:
1. Edit front side with YOUR information
2. Print both sides at about the same size (scan was at high resolution).
3. Glue front side onto index card, cut out and glue onto back side.
4. Trim sides, and place inbetween laminate sheets.
5. Laminate carefully with clothes iron (careful not to trap air inside and over heat plastic)
6. Trim product to standard wallet card size.
7. Go to a bar/club and try for yourself.

x_Darkstorm_x (2009-03-13)

Perhaps it would be nice to put "Canadian Government" in the title? After all, we in the lower 48 have as much motivation for buying beer with a fake ID as you guys. :)

gimp101 (2010-01-05)

hay darkstorm idiot. canadian id works in the us too. just like us id works in canada. if it didnt wy would 18 year olds talk about going to canada for booze. and this id looks a little strange. was it like a 1 year temp or something.

mista_g_ (2010-02-20)

No gimp101, it was not a temp license, though this scan is dated. Manitoba has since upgraded their driver's license technology.