Seagate 1.5TB ST31500341AS Firmware Update

----------------------------------------------------- [SEAGATE ST31500341AS |1,5TB|32MB Cache|7200RPM] ----------------------------------------------------- >>>>>>>>>>>>> Drive model : ST31500341AS <<<<<<<<<<<< ----------------------------------------------------- THESE ARE LEGIT FIRMWARES FOR THIS DRIVE AND THEY BEEN TESTED AND WORKING FINE! There are some serious problems with early shipped Seagate 1,5TB drives , model # ST31500341AS , with early firmwares. So here are 2 .ZIP files with updated firmwares for it's drive with different FW listed further below. The steps are simple: - To make a bootable floppy-diskette then run the .EXE file and insert a empty floppy disk. - To make a bootable CD-ROM then burn the .ISO image to a CDR. Either way, you need to reboot your PC with the bootable madia inserted then follow directions by the flash tool when booted. READ carefully the FWReadMe.txt files found in the ZIP files. I RECOMMEND YOU REMOVE OTHER DRIVES CONNECTED TO YOUR MOTHERBOARD/CONTROLLER AND KEEP ONLY THE DRIVE YOU WANT TO UPDATE CONNECTED! ----------------------------------------------------- IF YOUR DRIVE LABEL IS : P/N : 9JU138-301 Firmware : CC1F, CC1G - You should update to Firmware: CC1H or later. USE : ST31500341AS_CC1H.ZIP ----------------------------------------------------- OR IF YOUR DRIVE LABEL IS : P/N : 9JU138-300 ,366 Firmware : SD17, SD15, SD18 - You should update to Firmware: SD1A USE : ST31500341AS_SD1A.ZIP ----------------------------------------------------- [SEAGATE ST31500341AS |1,5TB|32MB Cache|7200RPM] ----------------------------------------------------- DO NOT TRY THIS IF YOU DON'T KNOW WHAT YOUR ARE DOING! GOOD LUCK! / Wackopath -----------------------------------------------------

udp://tracker.openbittorrent.com:80
udp://open.demonii.com:1337
udp://tracker.coppersurfer.tk:6969
udp://exodus.desync.com:6969

cap-jak (2009-01-21)

Anyone confirm that this torrent doesn't brick their drive? Specifically someone with a ST31500341AS and SD17.

isotope (2009-01-22)

I strongly suggest not to flash your drives until a few days have gone and seagate has time to figure out what is going on, and if SD1A is broken too.
If you are worried about your hard disk failing just don't power off the computer.

wackopath (2009-02-21)

These Firmwares ARE legit and they work 100%.
Drive 1 : ST31500341AS
Firmware: CC1G ---> patched to CC1H
S/N: XXXXXXXX
P/N: 9JU138-301
Date code: 09205
Site code: TK
Drive 2 : ST31500341AS
S/N: XXXXXXXX
P/N: 9JU138-336
Firmware: SD19 ---> patched to SD1A
Date code: 09212
Site code: TK
I asure you they work fine ,you must read carefully the info inside of each .zip file before you do your update.
@ seagates site they got a "serial-check" page
where you can look up your drive if it is affected by using the drives s/n.
Try here:

/wackopath

Lovok (2009-03-06)

There is newer SD1B firmware available ...